Subject: Re: [linux-audio-user] Delta 1010LT Preamp Gain
From: Paul Perkins (speaker-to-vegetables_AT_pobox.com)
Date: Tue Sep 23 2003 - 19:27:09 EEST
I can tell you that there are old fashioned physical jumpers on the Delta
1010LT card that you are supposed to set one way for line-level and another
way for mic-level input. One set of jumpers for each of the two lines that
have mic pre-amps on board.
On Tuesday 23 September 2003 11:06 am, Greg Reddin wrote:
> Does anyone know if the ADC 0 and ADC 1 controls on envy24control
> actually control the preamp gain on the M-Audio Delta 1010LT or would
> it just be the AD converter levels?
>
> My eventual goal is to use my DAW as a PA processor for small road
> gigs using Freqtweak or something similar for the master EQ and
> dynamics processing for FOH and monitors. As a proof of concept I
> connected the XLR outputs of an Allen & Heath console to the XLR
> inputs of my Delta 1010LT and connected the outputs of the Delta
> 1010LT to the power amp. I was not able to get good levels without
> distortion and I suspect it is because I need to decrease the gain on
> the mic preamps in the 1010LT. I would've connected to the
> line-level RCA inputs, but I didn't have a cable handy to try that.
>
> The problem seemed to persist even if I lowered the faders on the
> console. So does the preamp gain sound suspicious or am I connecting
> something with too much of an output level to a mic preamp to begin
> with or does it seem like something else? I'm pretty sure I'm not
> driving the amps with too much level frin the DAW.
>
> Any help is greatly appreciated.
> Greg
>
>
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! SiteBuilder - Free, easy-to-use web site design software
> http://sitebuilder.yahoo.com
This archive was generated by hypermail 2b28 : Tue Sep 23 2003 - 19:49:50 EEST