Re: [linux-audio-user] Re: UPDATE insmod errors - rme hammerfall multiface UPDATE

New Message Reply About this list Date view Thread view Subject view Author view Other groups

Subject: Re: [linux-audio-user] Re: UPDATE insmod errors - rme hammerfall multiface UPDATE
From: Thomas Charbonnel (thomas_AT_undata.org)
Date: Fri Feb 06 2004 - 21:23:04 EET

rob canning wrote :
> Hi Thomas,
>
> hdsploader cand find my card for some reason:
>
> hdsploader:
> [root_AT_localhost robcanning]# hdsploader
> hdsploader - firmware loader for RME Hammerfall DSP cards
> Looking for HDSP + Multiface or Digiface cards :
> Card 0 : Intel ICH5 at 0xfebfb800, irq 5
>
> yet lspci -vv reveals:
>
> 03:0c.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev
> 32)
> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR+ FastB2B-
> Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> Latency: 64
> Interrupt: pin A routed to IRQ 5
> Region 0: Memory at feae0000 (32-bit, non-prefetchable) [size=64K]
>
>
> thanks,
>
> rob

Hi Rob,

You should first check if the module was properly loaded (/sbin/lsmod),
then check you modules.conf file. In one of your previous mails one hdsp
line looked dodgy :

alias snd-card-0ntitlntitled 1ntitled 1ed 1 snd-hdsp

Maybe you should run alsaconf again to start from a clean basis.

Hope this helps,
Thomas

New Message Reply About this list Date view Thread view Subject view Author view Other groups

This archive was generated by hypermail 2b28 : Fri Feb 06 2004 - 21:27:53 EET