Subject: Re: [linux-audio-user] jack + spiralsynthmodular
From: Hannu Savolainen (hannu_AT_opensound.com)
Date: Wed Dec 08 2004 - 18:33:29 EET
On Wed, 8 Dec 2004, Artem Baguinski wrote:
>
> hello
>
> if i use OSS module of SSM and set it up to output only i get nice
> output
>
> if i set it up for duplex i hear some clicks
There are few possibilities to look at:
1) Make sure the same sound card is used both for input and output. Two
(separate) sound cards never run precisely at the same rate unless they
are syncronized together in some special way. If there is any drift in the
rates this will cause underruns or overruns. Maybe once per few seconds or
minutes.
2) If the system load is too high (or the buffer size set to too
small) then there will be buffer underruns. Each of them will cause a
pause/click.
3) There is some bug in the application logic and it just let's the buffer
to drain before writing new data.
Best regards,
Hannu
-----
Hannu Savolainen (hannu_AT_opensound.com)
http://www.opensound.com (Open Sound System (OSS))
http://www.compusonic.fi (Finnish OSS pages)
OH2GLH QTH: Karkkila, Finland LOC: KP20CM
This archive was generated by hypermail 2b28 : Wed Dec 08 2004 - 18:39:57 EET