On Fri, 2005-01-28 at 22:42, Kevin Ernste wrote:
> After further testing I found that the lack of sound on the headphone
> out occured on my system only with rdt kernels from PlanetCCRMA (go
> figure). Other Planet kernels. including
> kernel-2.6.10-2.1.ll.rhfc3.ccrma work perfectly with the new driver.
That is strange. If you installed the 1.0.8 alsa-kernel-module packages
for both then they should all be using the same version of of the hdsp
kernel mdoule....
> I will investigate the cause, but wanted users watching this thread
> and planning an upgrade not to hesitate. The recent patches to hdsp.c
> are a godsend, thanks again, Thomas.
-- Fernando
> On Fri, 28 Jan 2005 16:35:23 -0500, Kevin Ernste <kevinernste@email-addr-hidden> wrote:
> > Thanks Lee. Good to know.
> >
> > My primary concern was that this error message appeared at a glance to
> > be related to the loss of signal in the Analog output ( "mismatch
> > (Line Out/Precise Pointer for control #22") and that this information
> > might be useful to Thomas should this issue be something other users
> > report with this new version.
> >
> > On Fri, 28 Jan 2005 16:21:36 -0500, Lee Revell <rlrevell@email-addr-hidden-job.com> wrote:
> > > On Fri, 2005-01-28 at 16:12 -0500, Kevin Ernste wrote:
> > > > Reloading the driver (via the alsasound service in my case) gives the
> > > > following error, perhaps related to the Analog out issue:
> > > >
> > > > Restoring sound driver settings /usr/sbin/alsactl: set_control:930:
> > > > warning: name mismatch (Passthru/Line Out) for control #21
> > > > /usr/sbin/alsactl: set_control:930: warning: name mismatch (Line
> > > > Out/Precise Pointer) for control #22
> > > > /usr/sbin/alsactl: set_control:930: warning: name mismatch (ADAT Lock
> > > > Status/Use Midi Tasklet) for control #23
> > > > /usr/sbin/alsactl: set_control:932: warning: index mismatch (1/0) for
> > > > control #23
> > > > /usr/sbin/alsactl: set_control:1025: bad control.23.value type
> > > > [FAILED]
> > >
> > > These messages are normal anytime you upgrade to a newer ALSA that has
> > > different mixer controls. They are harmless, when you "alsactl restore"
> > > an old config any new controls get the default value.
> > >
> > > Maybe the error message should make it clear that this is normal if you
> > > just upgraded ALSA.
> > >
Received on Tue Feb 1 04:15:06 2005
This archive was generated by hypermail 2.1.8 : Tue Feb 01 2005 - 04:15:06 EET