On Mon, Feb 27, 2006 at 09:17:54AM -0500, Paul Davis wrote:
> aplay -D plughw:1,0 file.wav
>
> this will actually put the output across all outputs, but it should
> accomplish most of what you want.
Aplay ran without any error messages but there was no output produced. I set
all of the channels to "on", and also tried enabling the "pass-thru" option
but none of this had any audible effect. Whenever I ran aplay again, the
channels ("punch status" in the /proc/asound/card1/rme9652 file) were somehow
reset to "off".
An example of /proc/asound/card1/rme9652 appears below.
I have searched the WEb for further information. Questions have been asked on
this and other mailing list concerning this card, but I can't find any answers
in the archives.
Any help would be much appreciated. When I get this working I will document my
findings to help others.
RME Digi9652 (Rev 1.5) (Card #2)
Buffers: capture cec00000 playback cee00000
IRQ: 11 Registers bus: 0xec000000 VM: 0xd0820000
Control register: 402d
Latency: 4096 samples (2 periods of 16384 bytes)
Hardware pointer (frames): 0
Passthru: no
Clock mode: autosync
Pref. sync source: ADAT1
ADAT1 Input source: ADAT1 optical
IEC958 input: Coaxial
IEC958 output: Coaxial only
IEC958 quality: Consumer
IEC958 emphasis: off
IEC958 Dolby: off
IEC958 sample rate: error flag set
ADAT Sample rate: 44100Hz
ADAT1: No Lock
ADAT2: No Lock
ADAT3: No Lock
Timecode signal: no
Punch Status:
1: off 2: off 3: off 4: off 5: off 6: off 7: off 8: off
9: off 10: off 11: off 12: off 13: off 14: off 15: off 16: off
17: off 18: off 19: off 20: off 21: off 22: off 23: off 24: off
25: off 26: off
Received on Tue Feb 28 08:15:13 2006
This archive was generated by hypermail 2.1.8 : Tue Feb 28 2006 - 08:15:13 EET