On Tue, Feb 28, 2006 at 08:10:32AM -0500, Paul Davis wrote:
> > ADAT Sample rate: 44100Hz
> > ADAT1: No Lock
> > ADAT2: No Lock
> > ADAT3: No Lock
>
> this suggests that you do not have correct connections established. at
> least one of these should say "Lock" or "Sync". what is the interface
> connected to, and how is clocking being handled?
It's connected to the optical input of an RME ADI-2 a/d d/a converter, the
clock setting of which is configured for slave mode, i.e., to synchronize with
the input signal.
The only output that works currently is /dev/audio1 (OSS emulation), which
sends output to all channels simultaneously. I have attempted using the -erc
operator of Ecasound to copy the output to different channels individually,
but short of trying all 27 channels I haven't been able to get any output
through to the converter.
When playing through /dev/audio1 the /proc/asound/card1/rme9652 parameters are
as follows. I am getting clicks in the output, for whatever reason.
RME Digi9652 (Rev 1.5) (Card #2)
Buffers: capture cec00000 playback cee00000
IRQ: 11 Registers bus: 0xec000000 VM: 0xd0820000
Control register: 45039
Latency: 1024 samples (2 periods of 4096 bytes)
Hardware pointer (frames): 0
Passthru: no
Clock mode: master
ADAT1 Input source: ADAT1 optical
IEC958 input: Coaxial
IEC958 output: Coaxial & ADAT1
IEC958 quality: Consumer
IEC958 emphasis: off
IEC958 Dolby: off
IEC958 sample rate: error flag set
ADAT Sample rate: 44100Hz
ADAT1: No Lock
ADAT2: No Lock
ADAT3: No Lock
Timecode signal: no
Punch Status:
1: off 2: off 3: off 4: off 5: off 6: off 7: off 8: off
9: off 10: off 11: off 12: off 13: off 14: off 15: off 16: off
17: off 18: off 19: off 20: off 21: off 22: off 23: off 24: off
25: off 26: off
Received on Wed Mar 1 04:15:08 2006
This archive was generated by hypermail 2.1.8 : Wed Mar 01 2006 - 04:15:08 EET