On Wed, 30 Aug 2006, Spencer Russell wrote:
> Do you have JACK set to playback only?
I did, yes, since I'm presently mixing already recorded tracks.
> If I recall, I had this problem with saved sessions. A new session
> would work, I think, but once I saved it and opened it again, I
> couldn't add a bus if JACK was set to playback only. If you set JACK
> to full duplex the problem should go away.
Indeed it did! Thank you _very_ much!
> I guess not a lot of people run Ardour with JACK on playback only.
Could be. Perhaps I don't need to change Jack's configuration based on
whether I'm tracking or mixing? (I do have a few saved configurations,
for example, because some projects I'm working on were recorded by
others with a different sample rate than I normally like to work with,
and it's a lot easier, and sounds better at least on my system, to just
adjust Jack than it is to resample the tracks.)
Alright, then ... on with the mix! :-)
-- ---------------------------------------------------------------------- Sylvain Robitaille syl@email-addr-hidden Major in Electroacoustic Studies Concordia University Faculty of Fine Arts / Music Department Montreal, Quebec, Canada ----------------------------------------------------------------------Received on Thu Aug 31 12:15:02 2006
This archive was generated by hypermail 2.1.8 : Thu Aug 31 2006 - 12:15:02 EEST