Hi Everyone,
I'm trying to use two audio interfaces (Guitar Link UC6102) in parallel in
Alsa on a UDOO board that runs Ubuntu. The two interfaces are connected on
the two USB 2.0 port available on the board: I'm not using any hub. In 20%
of the cases, this works fine and I'm able to use the two interface as one
single "virtual" interface with 4 inputs and 4 outputs (see my .asoundrc
file bellow). However, in 80% of the cases, this doesn't work and dmesg
says: "cannot submit datapipe for urb 0, error -28: not enough bandwidth".
Any idea of where this problem comes from? I can use 4 of these interfaces
on the same USB port with a hub on my laptop without any problem...
Thanks for your help :)
Cheers,
Romain
.asoundrc:
pcm.myMAIN {
type route;
slave.pcm {
type multi;
slaves.a.pcm "myOUT0";
slaves.b.pcm "myOUT1";
slaves.a.channels 2;
slaves.b.channels 2;
bindings.0.slave a;
bindings.0.channel 0;
bindings.1.slave a;
bindings.1.channel 1;
bindings.2.slave b;
bindings.2.channel 0;
bindings.3.slave b;
bindings.3.channel 1;
}
ttable.0.0 1;
ttable.1.1 1;
ttable.2.2 1;
ttable.3.3 1;
#ttable.0.2 1; # front left
#ttable.1.3 1; # front right
#ttable.0.4 1; # copy front left to rear left
#ttable.1.5 1; # copy front right to rear right
}
ctl.myMAIN {
type hw;
card CODEC;
}
pcm.builtIn {
type hw
card vt1613audio
}
ctl.builtIn {
type hw
card vt1613audio
}
pcm.myOUT0 {
type hw
card CODEC
}
ctl.myOUT0 {
type hw
card CODEC
}
pcm.myOUT1 {
type hw
card CODEC_1
}
ctl.myOUT1 {
type hw
card CODEC_1
}
-- Romain Michon PhD Candidate Center for Computer Research in Music and Acoustics Stanford Universityhttp://ccrma.stanford.edu/~rmichon
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user@email-addr-hidden
http://lists.linuxaudio.org/listinfo/linux-audio-user
Received on Wed Jan 29 00:15:03 2014
This archive was generated by hypermail 2.1.8 : Wed Jan 29 2014 - 00:15:03 EET