[LAU] midi to cv: can't get below 5ms delay

Hi all!

I'm running reaper 6.05 on a raspberry pi 4 running raspbian/debian buster. I can't get rid of the last 5ms of latency between the midi note send and the trigger of my midi-to-cv interface (controlling my modular).

I played around with buffer settings in jack and the delay gets smaller as I decrease the buffer. However, no matter how low I set the buffer size, the "offset output to this device" in the preferences will not make the delay less than 5ms.

My setup is like this: reaper -> midi mate ii (usb midi interface) -> midi splitter -> cv.ocd (midi to cv interface) gate out -> soundcraft mtk 22 (mixer with usb audio interface). I also tested with the midi splitter out of the picture, same results.

I realize there will always be some delay, what surprises me, it that I can't adjust the delay so lo that the midi note and the recorded trigger align. With offset at 0 I get 15 ms delay with "reasonable audio buffer", adjusting the offset even to -100ms will still give me the trigger 5ms after the mid note. I'd expect -100ms to over compensate to the point of the trigger being recorded 85ms early...

Any input would be highly appreciated!

https://www.dropbox.com/s/hlvmls7c850i2ia/midi_delay_reaper.png?dl=0

-- 
Atte
http://latestyoutube.a773.dk | http://a773.dk
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user@lists.linuxaudio.org
https://lists.linuxaudio.org/listinfo/linux-audio-user