Re: [LAU] Qtractor 0.9.19 from source tarball

On Tue, 22 Dec 2020 09:07:16 +0000 Rui Nuno Capela wrote:

> On 12/21/20 7:51 PM, John Murphy wrote:
> > Mint 20 on an intel NUC
> >
> > I think I must be missing an obvious step here. Following instructions
> > from the qtractor-manual-and-howtos.pdf section 2.2. Hadn't used
> > 'apt-get build-dep' before, so I tried it:
> >
> > $ sudo apt-get build-dep qtractor
> > Reading package lists... Done
> > E: You must put some 'deb-src' URIs in your sources.list
> >
> > I usually use Synaptic to install dependencies, so I went that way, but:
> >
> > john@NUC1:~/qtractor-0.9.19/src$ ./configure --help
> > bash: ./configure: No such file or directory
> >
> > and, sure enough, there is no such file.
> >
> > Do I need to install 'autoconf' and run that somehow?
> >
>
> yes, you need to install autoconf and a buch of other -dev packages as
> well... and the correct source tree is probably
> john@NUC1:~/qtractor-0.9.19 (not under src) where you may find a couple
> of README files that might interest you first than reading the
> (outdated) user manual...

It was an interesting diversion and autoconf didn't seem too difficult,
but I gave up at automake with a greater appreciation of easier ways.

( I was following http://mij.oltrelinux.com/devel/autoconf-automake/ )

>
> but,IMHO you'll be far better with some pre-built packages from one of
> the repositories listed here:
> https://launchpad.net/~rncbc
> assuming the "focal" is the one for you:
> sudo add-apt-repository ppa:rncbc/focal
> sudo apt-get update
> then you may either use Synaptic or the command line to install the
> complete and fully-functional qtractor package:
> sudo apt-get install qtractor

Done in a flash that way. Thank you. And found my u-he Repro-1 VST2.

Sorted! :)

-- 
Thanks again.
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user@lists.linuxaudio.org
https://lists.linuxaudio.org/listinfo/linux-audio-user