Subject: Re: [linux-audio-dev] question re: hammerfall cards
From: Paul Davis (paul_AT_linuxaudiosystems.com)
Date: Wed Feb 26 2003 - 19:00:13 EET
>a) It looks like the Hammerfall driver doesn't have a mixer interface, is
>this correct ?
the hardware has no mixer.
>b) It looks like the onboard audio chip is controlled by an OSS driver, it
>doesn't show up in the alsa drivers either, which is fine by me, since I'm
>not going to use it. Is there any problem with OSS modules being loaded
>at the same time as ALSA modules ?
shouldn't be a problem.
>c) I bought the card so I could record optical S/PDIF. The manual says I
>need to tell the card that I want the ADAT1 Input source to be Optical
>S/PDIF.
[ ... ]
>Which I read as the Input source being ADAT optical instead of S/PDIF.
>How do I set it to S/PDIF ?
there are a couple of ways. alsactl is probably the most obvious:
% alsactl -f foo store
... edit "foo" ...
% alsactl -f foo restore
in the file "foo" generated by the first step, you will find lots of
stuff, including this:
control.5 {
comment.access 'read write'
comment.type ENUMERATED
comment.item.0 ADAT1
comment.item.1 Coaxial
comment.item.2 Internal
iface PCM
name 'IEC958 Input Connector'
value Coaxial
}
control.6 {
comment.access 'read write'
comment.type BOOLEAN
iface PCM
name 'IEC958 Output also on ADAT1'
value false
}
You will want yours to look like this:
control.5 {
comment.access 'read write'
comment.type ENUMERATED
comment.item.0 ADAT1
comment.item.1 Coaxial
comment.item.2 Internal
iface PCM
name 'IEC958 Input Connector'
value ADAT1
}
control.6 {
comment.access 'read write'
comment.type BOOLEAN
iface PCM
name 'IEC958 Output also on ADAT1'
value true
}
which will then do S/PDIF I/O over the ADAT1 connector.
using amixer is quicker but terser and you have to know/understand a
bit more to use it confidently.
>d) the card came with a sub-D-connector that connects to the card's 15 pin
>port, which branches off two RCA jacks. I don't suppose these RCA jacks
>provide an analogue output by any chance on which I can monitor for sound
>?
no, they are for co-axial S/PDIF output. there is no analog I/O of any
kind on this card.
--p (hammerfall driver author and happy owner of 4 of them :)
This archive was generated by hypermail 2b28 : Wed Feb 26 2003 - 18:55:11 EET