Re: [LAD] jcgui-0.4 initial release

Sorry, Ralf, I can't hear a different, when I set all controllers in
Jc_Gui to zero, and move the wet/dry slider to the right side, connect
ONLY Jc_Gui:in_0 /in_1 and out_0 /out_1, or disconnect jconvolver from
Jc_Gui and run it plain.

In the Jc_Gui engine, in this case, only additions and multiplications
with 0 was add/sub, the only diff is the use from denormal protection,
witch is needed for the tone unit. + 1e-20 , I can't believe that one
could hear that.

Only when you connect all 4 Jc_Gui ports for in and output, the source
will double up and overdrive.

regards hermann

Am Dienstag, den 29.12.2009, 08:51 +0100 schrieb Ralf Mardorf:
> hermann wrote:
> > Mostly you need to recalibrate the gain setting in jconv settings widget
>
> Correct, this was the reason for not really getting reverb, but now
> there's another problem. The sound is muddy.
> I'm not able to get the sound as bright and clean as it is for the
> attached configuration. I don't think it's because of the mono input, it
> sounds like there would be bad EQ settings, but the EQ's for Jc_Gui are
> set to 0. The signal tends to overdrive, it's not easy to keep the
> balance between the jconvolver widget and the additional Jc_Gui mixer.
> Anyway, LAD might be the wrong forum for this, I should join a user list
> for solving this issue.
>
>

_______________________________________________
Linux-audio-dev mailing list
Linux-audio-dev@email-addr-hidden
http://lists.linuxaudio.org/listinfo/linux-audio-dev
Received on Tue Dec 29 20:15:03 2009