On Thu, Aug 12, 2010 at 12:42:49PM -0700, Niels Mayer wrote:
> On Wed, Aug 11, 2010 at 1:35 PM, <fons@email-addr-hidden> wrote:
> > Not really, EQ normally being pre-fader. Post-fader meters in a mixer
> > strip are useful only of the signal being metered is actually one
> > that is physically available on some connector, e.g. as a direct out.
> > It would not indicate any overload that occurs pre-fader.
>
> The only time I've seen EQ pre-frader is low-cut on a microphone
> preamp.
Then you haven't seen any of the >100 mixers I've seen and
worked on. In fact, as far as I can remember, I've *never*
seen any mixer that had its EQ post-fader. Nor one with
post-fader inserts, and there are good reasons for that.
Ciao,
-- FA There are three of them, and Alleline. _______________________________________________ Linux-audio-dev mailing list Linux-audio-dev@email-addr-hidden http://lists.linuxaudio.org/listinfo/linux-audio-devReceived on Fri Aug 13 00:15:02 2010
This archive was generated by hypermail 2.1.8 : Fri Aug 13 2010 - 00:15:02 EEST