Quoting Paul Davis <paul@email-addr-hidden>:
> ClamAV 0.95.2
>
> On Tue, Jun 29, 2010 at 4:03 PM, J. <jonathangoodman@email-addr-hidden> wrote:
>
>> (1) Why when the jack control setup says sample rate 44.1 the status says
>> 48. All I need at this point is 44.1 who do I change it to that.
>
> you can't. you are using consumer audio hardware that only runs at
> 48kHz. it "works on windows" because the windows driver lies about it,
> and does resampling.
Well he claims to have an Audiophile 2496.
Assuming that's true and that he's hearing the sound come out of that
card and not any built-in, the only thing I can think about is if
something is holding the card in the wrong state.
J, from the command line run 'sudo aptitude install alsa-tools-gui' to
install the control panel for the 2496, and then start it by running
'envy24control'.
Go to the Hardware Settings tab and make sure that Locked isn't
checked and that Reset is, in the Rate State setting.
You also might want to set Master Clock to 44100 in that tab.
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user@email-addr-hidden
http://lists.linuxaudio.org/listinfo/linux-audio-user
Received on Wed Jun 30 20:15:11 2010
This archive was generated by hypermail 2.1.8 : Wed Jun 30 2010 - 20:15:11 EEST