Subject: RE: [linux-audio-dev] LADSPA Update (http://www.ladspa.org)
From: Richard W.E. Furse (richard_AT_muse.demon.co.uk)
Date: Sat May 20 2000 - 04:47:36 EEST
Hmmm. Yes - and entirely my fault, not Jezar's!
In fact I should have set a recommended range of 0 to 1 for all control
parameters. I'll rebuild it and send to Jezar - hopefully he'll publish the
fixed version. Perhaps the docs should be updated too. I've been meaning to
look at this in more detail (e.g. does it recover from the messy state once
parameters are controlled etc) - but I'm a little short of time at the
moment.
-- Richard
-----Original Message-----
From: Juhana Sadeharju [SMTP:kouhia_AT_nic.funet.fi]
Sent: Friday, May 19, 2000 10:52 PM
To: linux-audio-dev_AT_ginette.musique.umontreal.ca
Subject: Re: [linux-audio-dev] LADSPA Update (http://www.ladspa.org)
>From: "Richard W.E. Furse" <richard_AT_muse.demon.co.uk>
>
>I've also ported Jezar's excellent Freeverb reverb to LADSPA from VST.
How it is actually used? I get irritating ringing only....
No instructions in readme.txt. Should the plug-in description itself give
more info about the parameters?
Ports: "Input (Left)" input, audio
"Input (Right)" input, audio
"Output (Left)" output, audio
"Output (Right)" output, audio
"Room Size" input, control, 0 to ...
"Damping" input, control, 0 to ..., logarithmic
"Wet Level" input, control, 0 to ..., logarithmic
"Dry Level" input, control, 0 to ..., logarithmic
time ../bin/applyplugin -s 1 \
../snd/noise.wav /tmp/test.wav \
../plugins/filter.so lpf 3000 \
../plugins/filter.so lpf 3000 \
../plugins/delay.so simple_delay 1 0.2 \
../plugins/JLPL.SO freeverb1 5.0 0.0 0.5 0.5
^^^^^^^^^^^^^^^^^
???!!
What is the order of parameters? And value ranges? Greater than 0.0, but...
Where are other parameters mentioned in readme.txt??
Juhana
This archive was generated by hypermail 2b28 : Sat May 20 2000 - 20:10:04 EEST