Subject: RE: [linux-audio-user] Determining the proper names of things
From: Mark Knecht (mknecht_AT_controlnet.com)
Date: Thu Sep 05 2002 - 23:09:51 EEST
Frank,
Well, isn't that insanely simple! ;-) It worked. No more error message
from Ardour. (Later, much later I'll check if it actually works doing MIDI.)
Cool. Thanks!
One last question, and I will go read the MIDI Howto this evening, but in
/proc/asound/dev I see 4 MIDI devices, MIDIC0D0, D1, D2 and D3. Where do I
learn about what each of these do? Do I have to read driver code or
something like that?
Thanks,
Mark
-----Original Message-----
From: linux-audio-user-admin_AT_music.columbia.edu
[mailto:linux-audio-user-admin_AT_music.columbia.edu]On Behalf Of Frank
Barknecht
Sent: Thursday, September 05, 2002 12:11 PM
To: linux-audio-user_AT_music.columbia.edu
Subject: Re: [linux-audio-user] Determining the proper names of things
Mark Knecht hat gesagt: // Mark Knecht wrote:
> Here are the 4 things I know to look at - /proc/asound/dev,
modules.conf,
> the first few lines of ardour.rc and what I see when I run ardour.
>
> /proc/asound/dev and /dev/snd have identical entries.
>
> My main question - what should go in the MIDI-port tag and device
> sections of ardour.rc? And how does one figure this out?
> [...]
> *******************
> My module.conf file:
> [...]
> alias snd-card-0 snd-emu10k1
So the Audigy/Emu card is your first card...
> [...]
> ardour.rc (SB replaced Trident, by hand, not right!)
>
> <?xml version="1.0"?>
> <Ardour>
> <MIDI-port tag="SB" device="/dev/snd/midiC1D0" type="alsa/raw"
> mode="duplex"/>
... then you have to use the first midi device, which is
/dev/snd/midiC0D0
ciao,
-- Frank Barknecht _ ______footils.org__
This archive was generated by hypermail 2b28 : Thu Sep 05 2002 - 23:19:54 EEST